Tesla Model S/X (2016-2021) Heater Blower Motor with Fan (1051864-00-A) | OEM-Equivalent Climate Control Solution

Why This Blower Motor is Critical for Model S/X Owners

• Model-Specific Compatibility: Exclusively engineered for Model S (2016–2021) and Model X (2016–February 2021), eliminating fitment guesswork .
• Complete Assembly: Includes the motor, fan blade, and resistor controller in a single unit, saving hours of labor compared to sourcing components separately .

Core Functions and Performance Metrics

• Rapid Airflow: Generates 1,100 CFM (cubic feet per minute) of airflow, capable of adjusting cabin temperature by 10°C in under 2.5 minutes (tested in Model S 2018) .
• Dual-Zone Optimization: Works in tandem with Tesla’s dual-zone system to direct air independently to front and rear vents, ensuring passenger comfort across all seating areas.
• Defrost Efficiency: Clears windshield frost in 45 seconds at maximum fan speed, a critical safety feature for cold-weather driving .

Signs of Impending Failure – Act Before It’s Too Late

• Reduced Airflow: Vents emit weak air even at maximum settings, often caused by worn fan bearings .
• Grinding Noises: Metallic grinding or squealing from behind the dashboard indicates internal motor damage .
• Intermittent Operation: Fan cuts out at low speeds but works at high settings, signaling failing motor windings .
• Error Codes: “HVAC Fan Fault” or “Blower Motor Malfunction” alerts on the touchscreen .

Engineering Excellence: Matching Tesla’s Original Standards

• Brushless Motor Design: Features a 12V brushless motor (vs. cheaper brushed motors) for 80,000+ hours of operation – equivalent to 12+ years of daily use .
• Balanced Fan Blade: Injection-molded ABS fan with aerodynamic curvature reduces vibration and noise to 60dB at maximum speed (15dB quieter than generic aftermarket motors) .
• Water Resistance: IP6K7-rated housing protects against moisture ingress, critical for Model X’s front trunk drainage system .

DIY Installation Guide (45–90 Minutes)

1. Safety Preparations:
   • Disconnect the 12V battery (located in the frunk for Model S/X) and wait 10 minutes for residual power to drain service.tesla.com.
2. Access the Motor:
   • Model S: Remove the glove box and HVAC cover behind the dashboard’s passenger side .
   • Model X: Disassemble the right-side footwell trim and remove the HVAC housing bracket.
3. Component Replacement:
   • Unplug the 3-pin electrical connector and remove 4 T25 Torx screws securing the motor assembly.
   • Transfer the resistor controller from the old motor to the new unit (if applicable) .
4. Post-Installation Testing:
   • Reconnect the battery and test all fan speeds. The system will auto-calibrate without need for diagnostics .

Warranty and Included Components

• 2-Year Warranty: Covers defects in materials and workmanship, with free replacement for non-repairable failures .
• Complete Kit: Includes the blower motor, fan assembly, resistor controller, and a PDF installation guide with Model S/X-specific diagrams .

Why Choose OEM-Equivalent Over Aftermarket

• Inferior Bearings: Generic motors use low-grade steel bearings that wear out quickly under Tesla’s high-load HVAC system .
• Software Incompatibility: Aftermarket parts may trigger “Fan Fault” errors due to mismatched voltage ratings .
• Noisy Operation: Generic fans produce up to 75dB of noise at max speed, disrupting cabin quietness .